Q17. When using a destructive Paint Inspection Gauge the NACE inspector must:

Q18. You are working as the only in-house NACE Level 2 Inspector in a shop setting when an independent 3 rd party NACE Level 3 Inspector, representing the owner, presents you with a copy of a Non Conformance Report (NCR) he has written for a NACE2/SSPC SP 10 centrifugal blast which you had previously approved.
Your FIRST preferred course of action is to:

Q19. When NACE/SSPC WJ 1 is referenced; what type of equipment would the Inspector expect to see on the job:

Q20. In the event of a conflict between the Product Data Sheet and the Specification:

Q21. You are the NACE Coating Inspector on a tank lining project and are asked to perform a high voltage holiday test after the coating applicators have completed their final repairs. After meeting all the confined space entry permit you enter the tank and notice a very strong odor of solvent.
Your first course of action should to:

Q22. Because a NACE Level 2 Inspector has been trained in specific destructive tests, it is up to the Inspector to decide if and when a destructive test is required.

Q23. You are a NACE Level 2 in-house inspector working in a shop. Your in-house requires you to perform a sleeve test to test for soluble salts; however the 3 rd party NACE Level 3 inspector, the owner, has a san smart meter and has achieved a very different result and has rejected the pre-cleaning.
Your FIRST course of action is to:

Q24. External coatings applied to buried pipelines are generally tested for:

Q25. Inspection and Test Plans are provided to:

Q26. Coating surveys may include which steps?
Select All That Apply:

Q27. Which concrete smoothing technique involves scrubbing a mixture of cement mortar over the concrete surface using ai cement sack, gunny sack, or sponge rubber float?

Q28. WJ-1 is always performed using UHWJ at pressures above 210 MPa (30,000 PSI)

Q29. You are the NACE Level 2 inspector reviewing the documentation from a NACE Level 1 you notice significant documentation errors.
Your FIRST preferred course of action is to:

Q30. The standards defining surface cleanliness achieved by centrifugal blast cleaning are:

Q31. Which standards are generally established by private-sector bodies and are available for use by any person or Organization, private or government?

Q32. Centrifugal blast cleaning requires:

Q33. A reinforced coating is