QUESTION 45
A customer has a large number of food-producing machines
* All machines are connected via Aruba CX6200 switches in VLANs 100.110. and 120
* Several external technicians are maintaining this special equipment
What are the correct commands to ensure that no rogue DHCP server will impact the network?

QUESTION 46
Your manufacturing client is deploying two hundred wireless IP cameras and fifty headless scanners in their warehouse. These new devices do not support 802.1X authentication.
How can HPE Aruba enhance security for these new IP cameras in this environment?

QUESTION 47
Refer to the exhibit.

With Core-1. what is the default value for config-revision?

QUESTION 48
You are setting up a customer’s 15 headless loT devices that do not support 802.1X. What should you use?

QUESTION 49
Your customer has an Aruba CX 6200F VSF stack with two switches. A third member (JL726A) needs to be added to the VSF configuration. What e the configuration that enables the new devices to join the VSF?

QUESTION 50
you need to have different routing-table requirements With Aruba CX 6300 VSF configuration.
Assuming the correct layer-2 VLAN already exists, how would you create a new SVI for a separate routing table?

QUESTION 51
Refer to Exhibit:

With Access-1, What needs to be identically configured With MSTP to load-balance VLANS?

QUESTION 52
What is a primary benefit of BSS coloring?

QUESTION 53
Which Aruba AP mode is sending captured RF data to Aruba Central for waterfall plot?

QUESTION 54
A customer is looking Tor a wireless authentication solution for all of their loT devices that meet the following requirements:
– The wireless traffic between the IoT devices and the Access Points
must be encrypted
– Unique passphrase per device
– Use fingerprint information to perform role-based access
Which solutions will address the customer’s requirements? (Select two.)

QUESTION 55
What is one advantage of using OCSP vs CRLs for certificate validation?

QUESTION 56
Due to a shipping error, five (5) Aruba AP-515S and one (1) Aruba CX 6300 were sent directly to your new branch office. You have configured a new group persona for the new branch office devices in Central, but you do not know their MAC addresses or serial numbers. The office manager is instructed via text message on their smartphone to onboard all the new hardware into Aruba Central.
What application must the office manager use on their phone to complete this task?

QUESTION 57
What is enabled by LLDP-MED? (Select two.)

QUESTION 58
Which standard supported by some Aruba APs can enable a customer to accurately locate wireless client devices within a few meters?

QUESTION 59
A large retail client is looking to generate a rich set of contextual data based on the location information of wireless clients in their stores Which standard uses Round Trip Time (RTT) and Fine Time Measurements (FTM) to calculate the distance a client is from an AP?

QUESTION 60
What is an Aruba-recommended best practice for hardening that only applies to Aruba CX 6300 series switches with dedicated management ports?

QUESTION 61
In AOS 10, which session-based ACL below will only allow ping from any wired station to wireless clients but will not allow ping from wireless clients to wired stations?

QUESTION 62
In an ArubaOS 10 architecture using an AP and a gateway, what happens when a client attempts to join the network and the WLAN is configured with OWE?

QUESTION 63
Which statements are true regarding a VXLAN implementation on Aruba Switches? (Select two.)

QUESTION 64
Which component is used by the Aruba Network Analytics Engine (NAE)?

QUESTION 65
How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?

QUESTION 66
your customer has asked you to assign a switch management role for a new user The customer requires the user role to View switch configuration information and have access to the PUT and POST meth0ds for REST API.
Which default AOS-CX user role meets these requirements?

QUESTION 67
Your Director of Security asks you to assign AOS-CX switch management roles to new employees based on their specific job requirements After the configuration was complete, it was noted that a user assigned with the administrators role did not have the appropriate level of access on the switch.
The user was not limited to viewing nonsensitive configuration information and a level of 1 was not assigned to their role Which default management role should have been assigned for the user?

QUESTION 68
A new network design is being considered to minimize client latency in a high-density environment. The design needs to do this by eliminating contention overhead by dedicating subcarriers to clients.
Which technology is the best match for this use case?