NO.30 If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?

NO.31 Which formula is used for calculating OSPF interface costs?

NO.32 A network administrator has a stack of four Dell EMC Networking S4800 Series switches. Each stack unit is configured with a different priority. Which switch will be elected as the management device?

NO.33 What accurately describes the comparison between stacking and VLT?

NO.34 Which fields are mandatory TLVs in a LLDP PDU frame?

NO.35 What are Network Address Translation (NAT) inside global addresses?

NO.36 Which port type should be used for only VLAN-unaware devices?

NO.37 What accurately describes the Simple Network Time Protocol (SNTP)?

NO.38 On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?

NO.39 What accurately describes OSPF?

NO.40 Which field of the 802.3 frame is used by network interface cards to synchronize their receivers?

NO.41 Which Layer 1 device can be used to enlarge the area covered by a single LAN segment?

NO.42 An Ethernet switch receives a frame from a directly connected host. The source MAC address of the frame is not present in the MAC address table for the switch. However, the destination address is present in the MAC address table.
What does the switch do with the frame?

NO.43 Which message is sent by a router when TTL expires?

NO.44 You recently joined a company as a junior-level network administrator. You have been tasked with designing the IPv4 scheme for five networks that will be used for training classrooms. These networks need to support no more than 28 devices each. Due to the existing network design, the senior-level network administrator has asked you to work on network 192.168.40.0/24.
If all networks must be made to logically start with the lowest numbered network and end with the largest numbered network, what is the network ID for the third network?

NO.45 Which IEEE standard defines the Data Link Layer, Discovery protocol?

NO.46 The IEEE separates the Data Link and Physical ISO layers into four sub-layers. Based on the exhibit, what is the correct order of these sub-layers; from lowest to highest?

NO.47 How many total addresses for network, broadcast, and host are provided with the subnet mask
255.255.255.240?

NO.48 Which IPv4 address is in the same network as the IP address 182.15.24.40/23 and assignable to a host device?