2023 Updated Verified H35-480_V3.0 Downloadable Printable Exam Dumps [Q17-Q39]

Rate this post

2023 Updated Verified H35-480_V3.0 Downloadable Printable Exam Dumps

The Ultimate Huawei H35-480_V3.0 Dumps PDF Review

Huawei H35-480_V3.0 (HCIA-5G-RAN V3.0) Certification Exam is an important certification for those who want to work in the field of 5G wireless networks. H35-480_V3.0 exam is designed to test the knowledge and skills of professionals in the area of radio access network (RAN) technologies, which are the fundamental building blocks of 5G networks. The Huawei H35-480_V3.0 exam covers a range of topics such as 5G RAN architecture, 5G RAN protocols, 5G RAN interfaces, and 5G RAN optimization.

QUESTION 17
Which of the following MML commands can be used to query version information relating to the software stored on the gNodeB?

LST VER

DSP SOFTWARE

LST SOFTWARE

LST PATCH

QUESTION 18
Which of the following can be used to check whether an antenna is reversely connected during NR single site verification?

Fixed-point CQT

DT around the site

Transmission test

VSWR test

QUESTION 19
Which type of information about NR cells is carried in the neighboring NR cell MRs reported by UEs? (Choose all that Apply)

RSRP

MACCE

PCI

QUESTION 20
In NSA networking, which of the following modes is used to anchor 5G NR?

OGSM

WCDMA

CDMA

LTE

QUESTION 21
In SA networking, the mobile country code (MCC) and mobile network code (MNC) information added on the gNodeB must be consistent with the PLMN information on the core network.

True

False

QUESTION 22
gNodeBs periodically send TPC commands to UEs over PDCCHs to control the transmit power of which of the following uplink channels or signals of UEs?

SRS

PUSCH

PUCCH

QUESTION 23
Which of the following frequency locking modes is not supported when the GENEX Probe is used to perform a CPE test?

ARFCN

PCI

Cell frequency

BAND

QUESTION 24
Which of the following parameters is related to the frequency-domain position of PBCH DMRSs?

Cell ID

PCI

SI-RNTI

Bandwidth

QUESTION 25
If multiple IP addresses are planned for a gNodeB and the next-hop IP addresses are different, which of the following route configurations is more suitable?

Source address route configuration

Dynamic route configuration

Destination address route configuration

Direct route configuration

QUESTION 26
Which of the following devices is used to implement service slicing on the 5G RAN side?

Antenna

BBU

AAU

RRU

QUESTION 27
According to 3GPP specifications, which of the following is not an RRC state in 5G?

RRC_IDLE

RRC_ACTIVE

RRC_CONNECTED

RRC_INACTIVE

QUESTION 28
In the inter-site DC solution, the X2 interface can be used to implement transmission interconnection between the LTE and NR sites. Which of the following is the requirement of the transmission delay in such case?

<40ms

<10ms

<30ms

<20ms

QUESTION 29
The purpose of replaying logfiles is to reproduce the test process. The GENEX Probe can work without license in this case.

True

False

QUESTION 30
E2E network device update is required for the evolution from 5G NSA networking to SA networking.

True

False

QUESTION 31
Which downlink data split modes are supported on the gNodeB side in the 5G NSA Option 3x architecture? (Choose All that Apply)

MCG_ONLY: only split to the MCG

SCG_AND_MCG: static data split

SCG_ONLY: only split to the SCG

SCG_AND_MCG: dynamic data split

QUESTION 32
During 5G single site verification, you only need to test the user access and rate. Other test items are analyzed in drive tests.

True

False

QUESTION 33
Which of the following can be used to check whether an antenna is reversely connected during NR single site verification?

Fixed-point CQT

DT around the site

Transmission test

VSWR test

QUESTION 34
The mmWave range is new for NR. It supports the largest bandwidth in a cell but has poor coverage capabilities. It requires high performance from RF components and generally applies only to line of sight (LOS) coverage.

True

False

The mmWave range is a new spectrum range for 5G NR, and it supports the largest bandwidth in a cell. However, it has poor coverage capabilities, as it requires high performance from RF components and generally applies only to line of sight (LOS) coverage. This makes it challenging to use in many applications, as it requires careful planning and implementation in order to ensure effective coverage.
https://www.gsma.com/futurenetworks/wiki/5g-implementation-guidelines/
5G Implementation Guidelines: NSA Option 3 – Future Networks
https://www.gsma.com/futurenetworks/wiki/5g-implementation-guidelines/
https://www.ericsson.com/en/ran
5G RAN – Radio Access Networks – Ericsson
https://www.ericsson.com/en/ran
https://www.5gamericas.org/wp-content/uploads/2020/12/InDesign-Understanding-mmWave-for-5G-Networks.pdf Understanding mmWave for 5G Networks 1 – 5G Americas
https://www.5gamericas.org/wp-content/uploads/2020/12/InDesign-Understanding-mmWave-for-5G-Networks.pdf The millimeter wave (mmWave) range is new for 5G NR (New Radio). It supports the largest bandwidth in a cell but has poor coverage capabilities. It requires high performance from RF components and generally applies only to line of sight (LOS) coverage.
The mmWave range is considered to be the higher frequency range of the 5G spectrum and it includes frequencies above 24GHz, such as 28GHz, 38GHz and 60GHz. These frequencies offer a large amount of bandwidth, which is necessary to support high-data rate services, such as ultra-high-definition video streaming, virtual reality, and the internet of things.
However, the mmWave range has poor coverage capabilities because the signals are easily blocked by obstacles such as buildings and trees, and they also have a shorter propagation distance than lower frequency bands. Therefore, mmWave range is generally used for high-density urban areas, and indoor environments.
Additionally, RF components for mmWave have to meet high performance requirements, such as high linearity, high gain and high power handling capability. Also, the mmWave signals are highly sensitive to the presence or absence of a clear line of sight (LOS) between the transmitter and the receiver, which makes it less reliable for non-line-of-sight (NLOS) coverage.

QUESTION 35
Which of the following 5G massive MIMO scenarios is more suitable for high rise office building coverage?

H45V12

H25V25

H110V6

H45V6

QUESTION 36
What is the maximum MIMO mode supported by Huawei 5G indoor CPE?

4T8R

2T2R

2T4R

4T4R

QUESTION 37
The mmWave range is new for NR. It supports the largest bandwidth in a cell but has poor coverage capabilities.It requires high performance from RF components and generally applies only to line of sight (LOS) coverage.

True

False

QUESTION 38
On an NSA network, the eNodeB immediately triggers the SgNB addition procedure after a UE attaches to the LTE network. If the SgNB addition fails, the eNodeB attempts to add the SgNB again until it is successful.

True

False

QUESTION 39
What is the maximum MIMO mode supported by Huawei 5G indoor CPE?

4T8R

2T2R

2T4R

4T4R