Q21. What is the purpose of Management ports located on the Rear Panel of the Orchestrator MHO-140?

Q22. In case of Correction, where is information about Owner stored?

Q23. How many power supplies are presented on MHO-140?

Q24. There’s a 23800 appliance with quad NIC in slot 5. What would be the name of port 3 on this NIC?

Q25. What will happen in case of NAT of the traffic passing through Management network?

Q26. What kind of cluster Dual-Site can be compared to?

Q27. What kinds of transceivers are supported on Orchestrator MHO-140?

Q28. What does the lldpctl command do?

Q29. For a VSX configuration – Which statement is wrong?

Q30. What is the basic installation sequence of the Orchestrator in case of single Orchestrator?
1. Create a Security Group
2. Configure Default Gateway
3. Connect with Serial Console cable to the Orchestrator
4. Configure IP for one of its Management interfaces
5. Connect an appliance to a downlink port
6. Change Orchestrator amount to 1
7. Browse to the Orchestrator’s WebUI

Q31. What is the default Distribution mode?

Q32. What is the default range of physical ports for downlinks on Orchestrator MHO-170?

Q33. Splitter cannot be used __________.

Q34. Which setting is required in order to connect an appliance with 40Gbps downlink interface and DAC to the Orchestrator MHO-140?

Q35. Orchestrator should be defined in SmartConsole as:

Q36. What is the default range of physical ports for downlinks on Orchestrator MHO-140?

Q37. What is the default IP range of Sync network (with no increment)?