Free JN0-682 braindumps download (JN0-682 exam dumps Free Updated Feb 04, 2023) [Q57-Q74]

5/5 - (1 vote)

Free JN0-682 braindumps download (JN0-682 exam dumps Free Updated Feb 04, 2023)

JN0-682 Dumps for Pass Guaranteed – Pass JN0-682 Exam 2023

FRAGE 57
Exhibit.

Referring to the exhibit, which two statements are correct? (Choose two.)

There are two tunnels to the remote endpoint.

The irb. 0 interface is the remote tunnel endpoint interface.

The source tunnel IP address is 192.168.100.11.

There is one tunnel to the remote endpoint.

FRAGE 58
A VXLAN adds 50 to 54 bytes of extra header information to an Ethernet frame. In this scenario, how would you accommodate this increased?

Increase the MTU on the Physical interface connected to the VXLAN network.

Increase the MTU on the VTEP interface connected to the VXLAN network

Only use switches as VTEPs.

Decrease the number VXLANs used

FRAGE 59
Exhibit.

You administer an EVPN-VXLAN fabric. You notice that there is no VXLAN traffic forwarding through the network.
Referring to the exhibit, which modification will solve the problem?

set firewall family inet filter allow-BGP term 1 from protocol udp set firewall family inet filter allow-BGP term 1 from destination-port 4789

set interfaces et-0/0/49 unit 0 family vxlan

set interfaces et-0/0/49 unit 0 family vpls

set firewall family inet filter allow-BGP term 1 from protocol tcp set firewall family inet filter allow-BGP term 1 from destination-port 4789

FRAGE 60
You are asked to scale the available bandwidth within your Clos data center network to support more east-west traffic. In this scenario, what are two ways to accomplish this task? (Choose two.)

Add leaf devices to increase available paths and bandwidth

Use aggregated interfaces in the fabric.

Add spines to increase available paths and bandwidth.

Interconnect all spines to increase available paths and bandwidth.

FRAGE 61
You administer an EVPN-VXLAN fabric. You notice that there is no VXLAN traffic forwarding through the network.

Referring to the exhibit, which modification will solve the problem?

set firewall family inet filter allow-BGP term 1 from protocol udp set firewall family inet filter allow- BGP term 1 from destination-port 4789

set interfaces et-0/0/49 unit 0 family vxlan

set interfaces et-0/0/49 unit 0 family vpls

set firewall family inet filter allow-BGP term 1 from protocol tcp set firewall family inet filter allow- BGP term 1 from destination-port 4789

FRAGE 62
You are troubleshooting a traditional Clos Layer 3 IP fabric in your data center. You are reviewing the BGP configuration for one of your spine devices.
Referring to the exhibit, which statement is correct?

This spine device will not install multiple next hops for remote destinations in its routing table.

This spine device will not install any routes for remote destinations in its routing table.

This spine device has three neighboring leaf devices.

This spine device has three neighboring spine devices.

FRAGE 63
You are logged in to Leaf 1. When examining the routing table, you notice that you have no routes from Leaf 2.

Referring to the exhibit, which two commands would you use to troubleshoot the problem?
(Choose two.)

From Leaf 2, issue the show route advertising-protocol bgp 172.16.1.2 command.

From Spine 1, issue the show route advertising-protocol bgp 172.16.1.1 command.

From Spine 1, issue the show route advertising-protocol bgp 172.16.1.2 command.

From Leaf 1, issue the show route receive-protocol bgp 172.16.1.1 command.

QUESTION 64
Exhibit.

Referring to the exhibit, you want to advertise the IRB routes between both routing instances.
Which two configuration parameters would be applied to accomplish this task? (Choose two.)

Apply policy irb-A under instance Tenant_c and apply policy irb-c under instance Tenant_A as import policies.

Configure auto-export under both routing instances.

Configure vrf-table-label under both routing instances.

Apply policy irb-A under instance Tenant A and apply policy irb-c under instance Tenant_c as export policies.

QUESTION 65
Which device provides microsegmentation in a data center network?

vSRX

EX4300

vMX

QFX5100

QUESTION 66
After configuring an IP fabric using EBGP as you protocol, you notice that not all of the routers are showing up in the routing tables. You have verified that all adjacencies have formed, and place and configured properly.
In this scenario, which statement is true?

The routers have not been configured with the multipath multiple-as parameter.

The routers have not been configured using the bfd-1 Liveness-detection parameter.

The routers have not been configured using the multihop parameter.

The routers have not been configured using the add-path parameter

QUESTION 67
You are building a new IP fabric data center underlay network and want to ensure predicted load- balancing behavior for traffic, traversing the fabric. What are two approaches you should take to satisfy the requirement in this scenario? (Choose two.)

Ensure that all spine devices are the same switched mode.

Ensure that all uplinks are 40GbE.

Ensure that every leaf node has an uplink spine node

Ensure that every node has a link to every other leaf node

QUESTION 68
Exhibit.

Referring to the exhibit, you have a data center with two PODs. Seamless EVPN-VXLAN stitching is used to facilitate communication between the PODs.
Which three statements are true in this scenario? (Choose three.)

AVXLAN tunnel can form between L2 and S1.

A VXLAN tunnel can form between S1 and S2.

AVXLAN tunnel can form between L1 and L2.

AVXLAN tunnel can form between L2 and S3.

AVXLAN tunnel can form between L1 and L4.

QUESTION 69
Exhibit.

A VXLAN has been created between devices leaf1 and Ieaf3.
Referring to the exhibit, which statement is true?

Traffic sent from host1 to host2 will be dropped on Ieaf3.

Traffic sent from host1 to host2 will be tagged with VLAN ID 100 when exiting Ieaf3.

Traffic sent from host1 to host2 will be tagged with VLAN ID 200 when exiting Ieaf3.

Traffic sent from host1 to host2 will be dropped on leaf1.

QUESTION 70
Exhibit.

The two data centers shown in the exhibit need to be connected using EVPN.
Which two statements are correct in this situation? (Choose two.)

Hosts in VLAN 10 can communicate with hosts in Data Center 2 using Layer 3.

Hosts in VLAN 10 can communicate with hosts in Data Center 2 using Layer 2.

Hosts in VLAN 202 can communicate using Layer 3 between data centers.

Hosts in VLAN 202 can communicate using Layer 2 between data centers.

QUESTION 71
You are an architect for an enterprise organization that currently operates three data centers with plans to expand to five data centers in the next year. You already notice large amounts of BUM flooding and must control this issue before implementing the next two data centers.
Which feature would address this issue?

type-5 routes

type-6 routes

mesh groups

VXLAN BUM traffic filter

QUESTION 72

You have deployed a multitenant EVPN-VXLAN fabric. You must have the routes in the BLUE VRF show up in the RED VRF. In this scenario, how would you achieve this goal?

Configure a VRF export policy on the BLUE VRF that matches the RED VRF route target.

Configure the RED route target in the BLUE VRF.

Configure the BLUE route target in the RED VRF.

Configure a VRF import policy on the RED VRF that matches the BLUE VRF route target.

QUESTION 73
Referring to the exhibit, you want to advertise the IRB routes between both routing instances.

Which two configuration parameters would be applied to accomplish this task? (Choose two.)