QUESTION 41
The cost of qualified Coating Inspection is normally offset by:

QUESTION 42
When NACE/SSPC WJ 1 is referenced; what type of equipment would the Inspector expect to see on the job:

QUESTION 43
Cold-applied tape

QUESTION 44
Eddy current DFT gauges are used to measure Dry Film Thickness in which of the following situations:

QUESTION 45
Dehumidification is defined as the removal of moisture vapor from the air to

QUESTION 46
Because a NACE Level 2 Inspector has been trained in specific destructive tests, it is up to the Inspector to decide if and when a destructive test is required.

QUESTION 47
The best choice of instrument for holiday testing of thick film concrete coatings is:

QUESTION 48
The primary purpose of Fireproofing coatings are to provide:

QUESTION 49
A failure caused by applying a coating too thinly is known as

QUESTION 50
You are the NACE Level 2 Inspector on a project where overcoating of galvanized steel is being performed. The specification references SSPC SP 16 as the surface preparation method. At the pre-job meeting operations personnel make it clear that abrasive blasting will not permitted. The Owner’s representative asks you what other methods might be used.
Of the options shown below, what would be the preferred option in this situation?

QUESTION 51
Inspection and Test Plans are provided to:

QUESTION 52
A reinforced coating is

QUESTION 53
Surface preparation methods for Non-ferrous metals are:

QUESTION 54
As a NACE Level 2 Inspector on a field job; prior to submission your documentation should always reviewed and approved by:

QUESTION 55
Examples of non-ferrous metals include
Select All that Apply:

QUESTION 56
NACE Standards include:

QUESTION 57
Which product, when closely inspected has a green or red layer of fusion bonded epoxy (FBE) that is visible directly on the steel?