NO.31 Which organization is responsible for certifying that products and technology satisfy Wi-Fi interoperability?

NO.32 Which statement is correct about Wi-Fi?

NO.33 You have designed a WLAN to satisfy primary coverage, secondary coverage, and capacity requirements.
However, you still do not have enough BLE radios to satisfy your location requirements. You want to fill the gaps with a low cost, BLE-only device.
Which Mist device will satisfy this requirement?

NO.34 Which site survey ensures that RF design requirements are satisfied?

NO.35 A microwave oven would be classified as which type of interference?

NO.36 A microwave oven would be classified as which type of interference?

NO.37 You are designing a wireless network that requires smooth roaming performance and redundant coverage from at least two access points at every location.
What ensures that both of these functional requirements are satisfied?

NO.38 Which SLE would you use to determine Wi-Fi interference?

NO.39 What is an 802.11 management frame transmitted by an AP?

NO.40 You are configuring your Mist network and you want to separate certain users into their own networks and VLANs. You are concerned about the network’s utilization and want to make sure that only a single SSID is sending beacons.
In this scenario, which feature would accomplish this behavior?

NO.41

Referring to the exhibit, what do you determine about the site’s Time to Connect SLE metric?

NO.42 You are configuring your Mist network and you want to separate certain users into their own networks and VLANs. You are concerned about the network’s utilization and want to make sure that only a single SSID is sending beacons.
In this scenario, which feature would accomplish this behavior?

NO.43 When would be the earliest opportunity to configure an access point (AP)?

NO.44 Which underlying technology does Mist use to calculate BLE location?

NO.45 What are two characteristics of the 2.4 GHz band when compared to the 5 GHz band? (Choose two.)

NO.46 You have just brought online a new site of AP43s. While verifying that everything looks good, you notice that all of the access points (APs) are reporting “insufficient power.” The APs are connected to an 802. 3at-capable switch.
In this scenario, what would be the cause of the error?