NEW QUESTION 38
What is industry best practice for ensuring that all equipment has been delivered to the site for an AV event?
Response:

NEW QUESTION 39
When pulling a group of cables through conduit, it is advisable to:
Response:

NEW QUESTION 40
A key objective for mounting AV equipment in a rack is to ___.
Response:

NEW QUESTION 41
Which device is used to verify signal integrity throughout a video system?
Response:

NEW QUESTION 42
According to industry best practices, what is wrong with the picture above?

Response:

NEW QUESTION 43
Heat dissipated by equipment in an AV rack is measured in:
Response:

NEW QUESTION 44
A network cabling test that verifies a signal can travel from one end of the cable to the other is called a(n) ___?
Response:

NEW QUESTION 45
What type of termination technique is used for a BNC connector?
Response:

NEW QUESTION 46
Which of the following does HDCP 2.0 support?
Select all that apply.
Response:

NEW QUESTION 47
What type of cable is shown in the following image?

Response:

NEW QUESTION 48
The number of times per second a display will draw the image sent to it is the ___.
Response:

NEW QUESTION 49
An architectural drawing was created using the SI scale of 1:200. You measure a distance of 13 millimeters on the drawing. What is the actual distance in millimeters?
Response:

NEW QUESTION 50
Before starting work in a finished space, it is recommended that the AV technician:
Response:

NEW QUESTION 51
Which testing tool can detect clipped waveforms?
Select all that apply.
Response:

NEW QUESTION 52
Which of the following information does the EDID packet contain?
Select all that apply.
Response:

NEW QUESTION 53
Which organization’s general safety codes and regulations must you follow when visiting a job site?
Response:

NEW QUESTION 54
A limitation of using the RTA method to adjust equalization is _____.
Response:

NEW QUESTION 55
Prior to disposing of waste on a job site what should the installer confirm first?
Response:

NEW QUESTION 56
When powering a system off, which device should you turn off first?
Response:

NEW QUESTION 57
What should you do after setting the control address of a device?
Response:

NEW QUESTION 58
What are possible reasons for no picture on the screen?
Select all that apply.
Response: